Printed ok with Bambu PLA glow green filament in my A1. A lot of stringing and part of the first layer of the roof sagged, but overall the printer did pretty good. I had it going at slow speed, so that might have contributed?

Printed great. I used Bambu PLA silk+ silver. the supports came off pretty clean, just needed a little touch up in some areas but nothing major. I will say, printing it flat meant that the top layers were right on the face and belly, which makes the model look a little rougher on the front. putting it at an angle will take longer and use more support material, but the final product will look cleaner.

Printed great and looks great! Thanks!

Printed great! thanks!

Prints great and looks great! Thanks!

Prints very fast, looks great. Only problem is the bottom is hard to remove from the plate. Definitely let it fully cool and then use a sharp tool CAREFULLY around the edge of the brim. Two of mine lost the bottom layer trying to remove them from the plate.

Printed well, works fine. It was a little short for my mouth

Printed on my A1 with Bambu PLA silk+ silver (plus basic red and white). It turned out awesome! Supports came off easy. My son loves it. Joints work perfectly and seem strong. Thanks!

This printed great on my A1 in Bambu PLA basic silver (plus black/white for the eyes). Came off the plate clean, articulates very well. Horn is not friction fit it will need glue, but once glued it works and looks great!

Printed on my A1. I used Bambu PLA basic yellow, black, red, and white. It turned out very good. Only issue was the color gosting bands in the yellow when it transitioned from black. Overall they were minor, but noticable. However, I think it's a balance between the color shift and the amount of waste. There were 91g of wasted filament between poop and the tower. I printed 4 of them.

Printed the plate with 100, they turned out great! Thanks!

Printed in PLA Silk on my A1. It looks beautiful and it functions great! It does generate a pretty dramatic seam line at the base that would be better if it could be hidden under the handle. Also, the very top of the handle needs some work to smooth out the finish. But as it is, it's a great functional print. Thanks!

Printed itin PLA, and initially had an issue where hot PLA would stick to it, but I saw a comment about adding silver tape, and now it works perfect.

Excellent print quality (PLA Matte, A1). Very cute little seal!

Exactly as described! These are loud, especially at first. after about a week they are a little less loud now, but still fun to click.

They work really well!

They printed great, they look nice, and they work! I've been using two of them for about a week to hold my towels on the outside of the shower glass, and they haven't had any issues. Printed in red PLA Matte on my A1.

The guns printed ok, but they are fragile. I broke two of them taking off the supports. If you're gentle with them, they will be fine.

Printed great on my A1. No issues, exactly as described. It's a little bigger than I expected.