a bit sharp on the edges but can be smoothed out with a. debuting tool and some sandpaper.

printed for my FIL who has Neropathy and struggles to grip his remote. I added fuzzy skin to the outer walls using a modifer to keep the inside smooth.

doesn’t fit my watch, but that’s a me problem. will scale it up and try again

printed in petg-cf

prints easy and perfect fit. used a bit of glue on the plate just in case.

works beautifully, however I had some bed adhesion issues with this profile. corner grids peeled up a bit and I did use glue on the build plate. still works but minor issues with corner warping.

works great, used some 3M mounting tape to attach and looks very clean. also appreciate that it uses a lot less filament. cubby on the left has the print installed. right is without for those wanting to compare a before and after.

The box lids are quite loose and come off easily, would be nice if they snapped on or had some other mechanism to prevent it easily coming off.

My kids favorite song right now so this was a big hit

this makes me laugh everytime I see it on my office mini fridge. thanks! only complaint would be the magnet holes are a bit too deep for the 6x3mm magnets I have. I made it work but could just be a me problem.

tried to use a .2mm nozzle instead of the standard .4mm and it didn’t work out well. reprinted using the 4 and it came out great. was hoping to make the lettering cleaner, it’s likely a me problem as I had either adhesion problems or issues with the nozzle scratching the lettering off of the base layer. either way this is a great print!

looks great. though warning the arrow on the front will waste quite a bit of filament do to the frequent change outs. I liked the look so it was worth it to me.

was slightly difficult to get the filament to “lock” in this clip

looks great! takes up a lot of space and is a bit tall if you’re using something like an ikea Alex drawer but that can be easily tweaked.

the magnet keeps popping out but using double sided tape keeps it in place for now.

had some stringing issues but that’s probably on me. I think adjusting the print order might help? it turned out great though.