Got free orange filament with my 3D printer purchase and just couldn't resist printing the Home Depot bucket of my dreams. It was my temporary printer poop bucket until I printed a proper one. Perfect design and print. Also the perfect size for a beer kozzie 😆

Great tool. I appreciate the set angle. Only issue I've run into is the blade coming loose. Glue would fix that, but then limit my ability to change out the blades, which defeats the purpose a bit in my book.

Tiny little tools of epicness. Has made the S2 much more effective. I also appreciate the size options greatly. I usually dry my filament a couple hours with the big one, a couple more on the small one, then the last few hours completely closed, and it's been working like a charm! Printed them in PLA, but they've held up to longterm drying of most filament types with no warning issues.

Love this design and it printed perfectly. Personally knocked off a star as the screws listed are too long for the design, and (more importantly) the screw slots on the button section are VERY fragile and break really easily. The design actually has a gap there, making it even more breakable. Had to break out the glue to fix it and get some shorter screws, but overall, good design!

Printed quick and perfectly!

Superb tool, and I appreciate the modular design and attachments. 10/10. I'd print it again if needed, but it's holding up amazingly after a lot of initial use.

Fair enough to say this is my favourite swatch design (and I compared A LOT!) Also greatly appreciate the 3D Filament Profile website and label compatibility. These are now a fundamental part of my printing setup.

Printed perfectly, and I love the design. However, its very difficult to use without a cap on the spool holder to stop it from bouncing about as you wind it. Which I notice are in the models photos, but not mentioned anywhere in the description, or linked it. I personally feel this cap is a fundamental need to make the spool fully functional.

Printed superbly. Wee bit of stringing, but that's probably due to my filament not being dry enough. its holding up perfectly after a respool and much use. Love the built in filament holder and the weight text embossed on it. Both great ideas. (Ignore the big green bit in my photo, that's from the respooler that it is currently in, as I mainly use it for respooling some troublesome filament spools)

So grateful for these designs, and all the brands already covered and continuing to be contributed by the community.. I've had a few cardboard spools so far, and these printed quickly and perfectly. Plus I'll be keeping them around for future reuse.

Printed like a dream!

Fantastic model and so helpful! Printed in PLA Basic and PLA Silk so far and I'll be keeping both for reference. Thanks for this awesome wee calibration tool!

Absolute must for vacuum packing. These have been amazing. Printed and tried one, then instantly printed 10 more. Used some double-sided tape to hold them in place in the vacuum bag, and they work a charm. Think I'll size them down a few percent when i print my next batch, just to better fit my air pump, but overall, absolutely flawless!

Great design, but I had some size issues fitting it together. I like the design enough that I'm going to do some adjustments myself and reprint a few of the troublesome bits to make it usable tho.

Has worked perfectly for every print I've done since putting it on. Required a bit of wiggling to get in place, but the description warned of that ahead of time, which I appreciated.