Magmabow

Elegant NAS (Zimaboard2)

Industrial Air Purifier

ESP Sense 3D Model files

Mini 2032 Battery Holder - Snap-fit

Wire Holder for Soldering

Mini Filament Pelletiser

Small, Elegant Display Stands/Blocks

Camera Rig Battery Holder

Mini Screwdriver Torque Adapters [7.3mm diameter]

Mini Arduino Giga Industrial Case

Non-slip phone holder

Arduino Bannou Case + PCB Design Files

Epoxy Mixing Trays

Versitile, Minimalistic Phone Holder

No-Crease Cash Clip

Cable Clips

Stackable Screw Organiser

Heat Gun Stand (33mm Handle)

Power Supply Cable Holder

Thread Reaming Tool

Good model. although Instructions for the outer copper muon detectors were a little bit unclear, I figured it out in the end.
I needed to drill out quite a few of the magnet holes, but i used a 0.6mm nozzle with 0.25mm layer height, which may have caused the imperfect holes.

Currently waiting for the designer to release the files of the two circular muon chambers on either end of the collider!

brajer.jan

CERN ATLAS Detector 1:100

0.2mm layer, 2 walls, 15% infill

minor print troubles, but that's my fault. good model overall

9arr3tt

Oversize Bambu Lab Hotend X1/P1

0.2mm layer, 2 walls, 10% infill

The arm didnt print very successfully with the given print profile, but im sure this isnt to blame on the creator. Ill have to re-print the arm and glue it on, even though that will probably leave a very obvious seam

The 3mf file also had sloppy color painting, so i had to re-do that myself 

good model overall though

CptObvious

Bangboo- Zenless Zone Zero

0.12mm layer, 2 walls, 15% infill

Earn this badge when one of your models achieves 5,000 successful prints.

Popular Model

Earn this badge when visit MakerWorld more than 20 days in last 30days UTC time

MakerWorld Guardian

Semi-automatic cable wrapper

Filament Label swatches

Adjustable nail holder

The only rope tensioner you will ever need