Search models, users, collections, and posts
Bio
Fairly new to the game, getting my first 3D printer in 2025, and knowing nothing about the intricacies of that, or of using Fusion. Like most things once you start learning it, it's not that hard, and I'm having great fun now that I'm up the learning curve a bit.
So dive in as the power of 3D printing IMHO is the ability to design solutions to your specific needs, and share what you learn.
I'm a life-long tinkerer and over-thinker of designs. I struggle with good enough vs perfection.
Achievements
MakerWorld Guardian
Active more than 20 days out of last 30 days UTC time
A simple shoulder washer to insulate a 3/8 X 24 antenna mounting bolt from the antenna mounting bracket, with included Fusion file to resize the washer, if required.
Resizeable Antenna Mount 3/8 - 24 Shoulder Washer
0
4
Share
0
0
0
Wonderful, fun print that was great for Christmas time entertainment for our guests.
I printed the standard/tight file, with supports turned on, using AMS on my H2S with no issues.
Thank you and I'll come back and give it a Boost when I earn some more.
Share
0
0
0
A great fit to seal off the screw access hole.
Share
0
0
0
Perfect! It's going to be a gift to a friend that has always had a Dex.
Share
0
0
0
The post is no longer available
Excellent design and print. Printed with PLA on my H2S with the default settings.
The two pieces snap firmly into place and in particular the circle portion perfects a secure assembly. Well done!
Share
0
0
0
Wow! Excellent print design, and I also learned a lesson with this being only my fourth print.
I did this print on a H2S using Bambu ABS filament with the default settings. All five prints were stringy and had rough surfaces, which I was surprised to see. The ABS filament was from a brand new still sealed bag, so presumably it was dry...
As a test I dropped the filament into my AMS HT for a few hours on drying, and then did another print, of just the large size basket — no strings at all, and the print was smooth. Perfect!
See the attached photos to compare of you're interested.
Share
0
0
0
Clean print and firm attachment to the factory Bambu filliment spools. Printed in PLA with the default settings.
Share
0
0
0
My third print on my H2S, and like the first two, this printed wonderfully. I didn't have the red that would be the circle above the "I", so I used yellow.
Share
0
0
0
No more data