I liked it a little slimmer, so I decreased its thickness. Works great, thanks for offering it up. I'm out of boost tokens right now but will send you one when I get more.

I doubled the size to print the largest pumpkin that would fit on the PS1. I used Elegoo Purple PLA and eSun Orange PLA Basic. All I had to do was to scale the parts and move the bottom cover to a separate plate. Turned out nice. Thanks!

Came out nicely using PETG. Thanks! (battery for size comparison)

I printed this model using a P1S loaded with Mika3D Silk Metallic Shiny Rose Gold filament. I printed it twice - at 100% and 200% scale. I think I prefer the larger size. The details are suited for a larger print and the wings look more impressive. Supports were not much of a chore to remove on either size. There are some rough spots on the back and the belly but some post-processing should take care of that. It will look nice added in our bookshelves. Thanks for uploading this model! Here are some pictures of the 100% scale print.

I used black Flashforge Silk PLA+ for this on the PS1. I might print the front cat again and try to use the ironing settings in Bambu Studio to make it look s little bit nicer, but it turned out as expected and fit well. It will be a nice addition to my daughter's space-themed hair salon opening next month. Thanks for the model! (benchy for size comparison) EDIT: I added another photo of the front piece that I printed with ironing the top layer (ironed on the left, original on the right). Although it smoothed out nicely with ironing, I'm sure I could play with the default settings to make it nicer. Still, it's an improvement. Your results may vary.

Nicely done. I printed it with some generic PLA on the P1S. Thanks!

Nice design. Fits well with the riser. I used PETG. Kind of tips away a little to the side, will have to keep an eye on that. Thanks!

I really liked printing and assembling this cabin. Light from inside shines nicely through the windows, and the snow can be left unglued and removed to fit the season, too. Good job.

These printed perfectly with no modifications using our new P1S. No problems assembling them. Beads are being delivered today. Thanks! Edit: Just in case anyone is interested, I used Elegoo PLA Black, and there were no supports needed.

Nice frog. Our son liked it very much. Printed with Bambu Green spooll from our new PS1 shipment. Thanks!