Search models, users, collections, and posts
Bio
I like 3d printing 👍😄
Achievements
MakerWorld Guardian
Active more than 20 days out of last 30 days UTC time
It is mostly good but the sword is hard to collapse into the handle. And when I push it down hard, it pops off the closing on the bottom. But I bet hot gluing it shut would work.
Edit: ok… AFTER HOT GLUING IT, IT IS THE BEST!!!!! 5 STARS, 5 STARS, 5 STARS!!!!!!!!
Share
0
0
0
I printed it twice and it’s super practical! I definitely recommend it!
Share
0
0
0
Strength Issue:It was great at the start but, the things that hold the cards in broke after a week and a half.
Share
0
0
0
Share
0
0
0
My dog loves it.
⚠️ Just if you scratch your dogs head watch out for the eyes!
Share
0
0
0
It is pretty good, but can anybody remix it to make the slide go a little bit lower because I have a dresser that my 3d printer stands on, and the dresser is not completely against the wall. The dresser has a “lip” in the picture shown where the slide would lean on. The overall problem for me is that the slide is not completely against the printer. Thank you if anybody remixes one.
Share
0
0
0
No more data