Nice design, good print. But the layers on the front legs seem to leave a small gap. Maybe it would be better if the angle is smoother. I don't think it's a printing error, everything else went great.

Very nice design! I did a test prints with .4 nozzle. Went quite well, but I chose a slightly difficult filament. .2 will definitely end up better

Very well designed and clear instructions. Printed perfectly. The on/off button is the most tricky piece to deal with.

Awesome! Strong enough while using less filament than other designs. I used the super draft version and am pretty satisfied with it. on the inside of the spool you can see imperfections, but it does the job and from the side it looks perfectly fine. Only suggestion is changing the weight note. The rim says 175 grams, while only 133 go into the spool.

Great print! Next time I'd scale it up to 150% to prevent walls sticking together when the printer leaves a bit too much filament.

The quality is good. Well designed overall. As seen in other comments the fit is really tight, but it's doable. the orientation of the engine isn't ideal, but given the gears in the kit, I don't think there's much of a choice there. 5 stars anyway because I haven't found an alternative that works with the beginner's kit.

Print came out really well. I had to do a little work after removing the supports, especially the teeth needed some sanding. But other than that it is great.

Lovely! Scaled them down without problem as well

I wanted to print the tiniest box. It almost worked! Only the lid doesn't fit, but that's my fault for making it so tiny. The design will be perfect if you use normal scale.

Perfect! Well designed, works exactly how it should. Print profile worked great too.

I scaled it down a lot and it still came out very nice.

Great design, fits perfectly. The print came out really well. Personally I find the bin a bit large. Had I looked further, I might have chosen a smaller alternative. But obviously, that's on me.