A1 Vibration Damping Pods I wanted to add particle damping to my A1 similar to how it is used in the new A2L. So, I created these. They mount to the brace that connects the X-axis to the Z-axis screws instead of the gantry. The mount is the point were any vibrations and or resonance would travel to the print head via the X-Axis screws – this way both X and Z axis have damping. Plus, space on my gantry is at a premium ! X-) Posting should someone else find this useful.

I got fed up with the A1's original #%*&%@} purge wiper tray getting bumped, bent and misaligned so I created this. It surrounds the tray and secures it into place so that it can't be bent and misaligned. It also adds a 3x4 section of silicon wiper. It’s not a clip on, It’s a direct replacement part so it stays secure and in place. Posting incase someone else might find it useful.(Edited)

I use this simple sturdy rack to organize the four filament boxes being used for each of my AMS. There is a top , middle, and bottom section so they can be combined to any height if needed.

An AMS 9 port hub to replace the stock 4 port. I'm adding a second BMCU AMS and wanted a hub with the capacity for both AMS tubes, and an additional External, that looked close to OEM. Sharing should someone else also find it useful.

It bothered me how close the screen is to the print bed on my A1 so I created this plug and play extension to relocate the touch screen a little further up and to the right. It only takes 12g of filament and 20-30 minutes following the Bambu Lab wiki for replacing the touch panel.

Hello, I need to keep my X-Axis cable clipped in tight & guide the cable backward. Clips limited height & Drag Chains too bulky, use alot of filament. So, I came up with this. It keeps the cable in tight to the printer, allows full range of motion. The clip rotates, moves forward, & up. If your tight on space, you might also find this useful for wrangling the X-Axis cable. https://makerworld.com/en/models/1759090-a1-x-axis-cable-articulated-mount#profileId-1871075