Keep Christmas simple - with this simple hollow Christmas bauble!
The bauble has two halves that are connected by the middle belt. It is hollow and has an opening on the top so you can put a LED inside (eg from a fairy light).

Print everything with three walls, 6 tops, 4 bottoms, 8% gyroid infill and no support. Use a brim on the belt and the two bauble halves to improve the bed adhesion. For quality lower all print speeds by 80mm/s. I like to use 0.8mm for z-hop but this is up to you. See my 3mf for details.

Assembly is very easy - screw both halves to the middle belt, then screw the stem on top. Insert the clip into the stem and decorate your home with your new bauble.

Disclaimer:
This work by blecheimer is licensed under CC BY-NC-SA 4.0
You are not allowed to copy this model to other 3D printing websites without my permission.