Unsinkable Boat - Spiral Vase Mode by BamBam Design

BamBam Design

Toys & Games>Other Toys & Games

Print Profile(2)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

[All SIZES to choose] Spiral Vase 0.2mm layer, 1 walls, 0% infill

Designer

5.4 h

5 plates

4.9(71)

0.2mm layer, 1 walls, 0% infill

1.2 h

1 plate

5.0(13)

Boost

253

449

186

890

1.2 k

Released

Description

Unsinkable Boat:

A cool little Boat which can't sink. It has Air Chambers to stay always above water.

It prints nicely in Spiral Vase Mode with 0,65-0,75mm Wall.

I upload a Profile with 5 different Sizes on 5 Plates. The Boats are stack-able then.

Nice little Toys for kids!

It's an honor if you give me a thumbs up and follow me.

Happy printing 😃👍

Commercial license you can get here:

https://www.patreon.com/BamBamDesign/membership

Comment & Rating (186)

@Girva

I’ve printed this 4 times, with the same problem each time. Gaps in the layers on the decorative side groves as it approaches the top. Anyone have any suggestions how to fix this? A1 printer, PETG and PLA, both have the same issues.

The designer has replied

@BamBamDesign

Hi Girva, thank you very very much for sharing that. I sometimes get bad ratings and i don't know why. Know i have a point i can tune the file. That seems for bad cooling! Could be X1/ P1 performed a bit better here! I will change the construction at the top layers a bit, i think smaller grooves should fix it, for not that heavy overhang! Thank you again👍🏼

@BamBamDesign

Replying to @BamBamDesign :

I just uploaded the overhang reduce on the top. Will be nice you can try.

@Girva

Replying to @BamBamDesign :

I tried the new file in the medium size with some brand new pink Bambu PLA. it was much better… But still has a few holes just in the top portion of the print. I’m quite new to printing so am not sure if it should try hotter/colder or slower/faster settings on my A1?

@colonel315

Boosted

Print Profile

[All SIZES to choose] Spiral Vase 0.2mm layer, 1 walls, 0% infill

one of the best designs and uses of vase mode I have ever seen

The designer has replied

@BamBamDesign

Wow thank you for perfect rating and the nice words🤗 Feel free to checkout my other designs as well😉

(Edited)

@colonel315

Boosted

Replying to @BamBamDesign :

will do 😃

@elwe

Print Profile

[All SIZES to choose] Spiral Vase 0.2mm layer, 1 walls, 0% infill

Really unsinkable. Thank you.

The designer has replied

@BamBamDesign

Really cool! Thank you for the nice pics of your makes👍

@Flame84

Print Profile

[All SIZES to choose] Spiral Vase 0.2mm layer, 1 walls, 0% infill

Great set of prints. The kids wanted the whole set. Depending on the filament though, it might or might not close the very top airtight, so need to be mindful of this and melt and pinch it a bit if it is open otherwise it fills up with water and becomes a submarine 😁