torsion spring catapult
Copyright Claim
torsion spring catapult
Boost
48
88
4
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
1.5 h
1 plate
Boost
48
88
4
2
112
55
Released
Description
simple catapult, easy to assemble. No supports are required to print and no tools for assembly
Comment & Rating (4)
All
The print profile is no longer public
Printing on the A1 using the printing profile. The screw for the catapult prints well, but the hole was too small. the wedge piece to attach the catapult to the base was also too big. I superglued the bucket and cut a small part of the wedge off and it works great!
The designer has replied
0
Reply
I have the A1 too... but not those problems...
0
Reply
Replying to @platini76
I printed in PLA, so maybe that was the issue. it happened with both prints I did.
0
Reply
Replying to @I.Danner
look on photo I uploaded on profile... for solve your problem you can scale pin 99 or 98%
(Edited)1
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld