Alien Xenomorph Mini-Figurine (10cm / 4in tall)
Copyright Claim
Alien Xenomorph Mini-Figurine (10cm / 4in tall)
Boost
48
111
11
Print Profile(1)
0.08mm layer, 4 walls, 15% infill, snug supports
Designer
6.4 h
1 plate
Boost
48
111
11
6
155
53
Released
Description
Original model (https://www.printables.com/fr/model/517548-alien-xenomorph-fan-art) by Printed Obsession: https://www.printables.com/@PrintedObsession
A friend needed a mini of a xenomorph for a board game. I found this model and tweaked the settings to get a great print on a scaled scaled-downdown version for the A1 mini.
After a couple of prints, I found this configuration to produce the best result and the easiest-to-remove supports.
Comment & Rating (11)
All
good model but took 30 sold minutes to remove supports
The designer has replied
1
Reply
It's definitely a work of patience :) Thanks for your feedback!
0
Reply
Print Profile
0.08mm layer, 4 walls, 15% infill, snug supports
unreal to remove suports
The designer has replied
0
Reply
Not sure what to tell you—I've printed 3 of these without issues. Feel free to change the support settings to something that better fits your needs
0
Reply
Boosted
The result is great, but it is difficult to remove the support
0
Reply
Print Profile
0.08mm layer, 4 walls, 15% infill, snug supports
Support Issue:It is impossible to remove the supports without breaking the figure. Bad finish.
The designer has replied
0
Reply
Not sure what to tell you—I've printed 3 of these without issues. Feel free to change the support settings to something that better fits your needs
0
Reply
Print Profile
0.08mm layer, 4 walls, 15% infill, snug supports
1
Reply
Print Profile
0.08mm layer, 4 walls, 15% infill, snug supports
Other Issues:Leider völlig fehlerhafter Druck. Konnte ich nur in den Müll werfen. Woran es letzlich lag, kann ich njcht sagen.
0
Reply
Print Profile
0.08mm layer, 4 walls, 15% infill, snug supports
Support Issue:Great model, but my A1M had alot of issues with the tail spines, and top of the horns on the back.
0
Reply
Print Profile
0.08mm layer, 4 walls, 15% infill, snug supports
Support Issue
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld