Glock 17
Copyright Claim
Glock 17
Boost
614
849
117
Print Profile(2)
0.2mm layer, 2 walls, 10% infill
Designer
5.7 h
1 plate
(FIXED) A1M Compatible PLA
5.4 h
2 plates
Boost
614
849
117
60
2.4 k
662
Released
Description
Glock 17 with movable parts (Trigger,Magazine)
on the spring part the support is a little bit tricky to remove
check out my other models too
Comment & Rating (117)
All
Print Profile
0.2mm layer, 2 walls, 10% infill
The designer has replied
4
Reply
thank you🙏🏼
0
Reply
how the hell did you get the supports off the spring without breaking it?
0
Reply
Replying to @nerk
patience and a sharp blade
(Edited)2
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
great model! I just had a bit of issues in printing the trigger in the original position. I re oriented it and re sliced it. all good!
The designer has replied
4
Reply
nice one!
(Edited)1
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 10% infill
great
The designer has replied
1
Reply
thank you :)
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
nice design, great for prop use
2
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
the Glock looks awsome
1
Reply
pěkný design
1
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
(Edited)
Support Issue: The sculpt is OK. No issues with the magazine like others have had. But the supports are excessive and I’ve never seen tree supports merge together like this. It’s just way too tight. Trigger broke even after I read the warnings.
0
Reply
no
0
Reply
How is everyone else printing them without problems?
(Edited)1
Reply
Replying to @casey_b_hughes
no
0
Reply
Print Profile
(FIXED) A1M Compatible PLA
almost broke a piece taking support out
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
Nice!
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 10% infill
Easy to print, but need glue
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld