Shoe Horn
Copyright Claim
Shoe Horn
Boost
27
40
15
Print Profile(1)
0.2mm layer, 4 walls, 50% infill
Designer
1.6 h
1 plate
Boost
27
40
15
4
82
93
Released
Description
A simple fully printed shoehorn used to help get shoes on foot.
Prints without support lying horizontally.
Have fun with it and leave a like or subscribe if you like it!
If there are any suggestions for improvement, feel free to write a comment.
Comment & Rating (15)
All
Print Profile
0.2mm layer, 4 walls, 50% infill
it works well use it all the time
0
Reply
Print Profile
0.2mm layer, 4 walls, 50% infill
nice strong print
0
Reply
Print Profile
0.2mm layer, 4 walls, 50% infill
I've been needing this for a while, great design, works perfectly.
0
Reply
Print Profile
0.2mm layer, 4 walls, 50% infill
It's tough enough to not brake printed in PLA, but it hurts a little because of the curved form. It pokes my foot with the end of the horn a little while using. Maybe a Design a little more linear should fix the 'problem'.
0
Reply
Print Profile
0.2mm layer, 4 walls, 50% infill
0
Reply
Print Profile
0.2mm layer, 4 walls, 50% infill
0
Reply
Print Profile
0.2mm layer, 4 walls, 50% infill
0
Reply
Print Profile
0.2mm layer, 4 walls, 50% infill
0
Reply
Print Profile
0.2mm layer, 4 walls, 50% infill
0
Reply
Print Profile
0.2mm layer, 4 walls, 50% infill
0
Reply
License
This work is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld