Motorcycle DNEPR M72 with sidecar 1:8
Copyright Claim
Motorcycle DNEPR M72 with sidecar 1:8
Boost
343
427
23
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
29.5 h
11 plates
Boost
343
427
23
19
836
78
Released
Description
A simplified model of the Dnepr M72 motorcycle adapted for printing on an FDM printer.
I recommend printing from PETG because of the better properties of the material.
A filament is used for smaller connections. In other cases, use instant glue.
Wheels are printed without supports, other supports must be removed carefully.
If the holes for the wheel axles and the steering axle are tight, I recommend using a drill with a diameter of 3 mm.
The assembly manual contains a detailed description including pictures.
Documentation (1)
Assembly Guide (1)
Manual_4469a21e-e17a-43b2-8a19-22cf3ef6fc9b.pdf
Comment & Rating (23)
All
Where is the post part? I don't see it in the model
The designer has replied
0
Reply
Sidecar_machinegun holder.STL in folder sidecar. Sorry, it was missing from the print profile. I filled it in there.
0
Reply
Replying to @radek.rypar
Got it, thanks.
0
Reply
Replying to @radek.rypar
Hallo wo bekomme ich denn das Fehlende Teil her???
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
good, but speed were hair
(Edited)
0
Reply
If you like removing supports, then this model is for you. I couldn't get a usable print of the engine until I switched to tree supports from the build plate. Why was not in the original model?
(Edited)1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Good...
0
Reply
Boosted
very fun design to assemble
0
Reply
Boosted
Excellent
0
Reply
nice post!
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Super Arbeit danke dafür
0
Reply
nun ist es komplett 😀super Arbeit sehr schön 🤩
0
Reply
没有一次能把支撑完美的拆下来，打印了3遍，全在拆支撑的时候坏了，放弃了。
0
Reply
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld