⬡ Hex Lamp for LED Strip Lights
⬡ Hex Lamp for LED Strip Lights
Boost
267
355
22
GIF
GIF
GIF
GIF
Print Profile(2)
Designers Suggested 0.2mm layer, 2 walls, 15% infill
Designer
8.6 h
1 plate
0.2mm layer, 2 walls inside, 1 wall outside, 15% infill
7.5 h
1 plate
Boost
267
355
22
31
307
112
Released
Description
I developed this to hold most of a 5m strip of LEDs, cut off or tuck in the remainder.
LEDs HERE https://us.store.bambulab.com/collections/led-strip-light?skr=yes
Super easy instructions:
Poke the wire through the bottom hole.
Remove backer and tightly stick the LED strip up the inner tube.
Put the parts together and plug in, so simple!
The remote receiver is outside the lamp and works perfectly!
Comment & Rating (22)
All
Boosted
Printed cover in white, transparent, and frosted transparent to see which I liked better. I still can't decide. Great model!
The designer has replied
3
Reply
wow!
1
Reply
Print Profile
Designers Suggested 0.2mm layer, 2 walls, 15% infill
Great lamp design, came.out really good!
0
Reply
Print Profile
Designers Suggested 0.2mm layer, 2 walls, 15% infill
(Edited)
0
Reply
This looks really nice, I should try it one day. Do you have any experience with the heat from the LED strip piling up and melting the PLA? I had some problems in the past and I'm asking if I should use PETG, or it was not a good LED strip (not from Bambu) and it can work with PLA.
The designer has replied
0
Reply
All mine are PLA and they don't get soft. I think it's just not hot enough to melt PLA. you can always use Petg
3
Reply
Replying to @TripleGWorkshop
Thanks a lot! Then I guess it's not the material, it's the LED strip. I need to buy these type.
Your lamps look beautiful!
(Edited)0
Reply
can the outside be done in another colour?
The designer has replied
1
Reply
Sure I just did white for max light
1
Reply
Print Profile
Designers Suggested 0.2mm layer, 2 walls, 15% infill
works great really love the design maybe a thiker top
0
Reply
Boosted
Print Profile
Designers Suggested 0.2mm layer, 2 walls, 15% infill
Love it.
0
Reply
Print Profile
Designers Suggested 0.2mm layer, 2 walls, 15% infill
excellent print result
0
Reply
Print Profile
Designers Suggested 0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
Designers Suggested 0.2mm layer, 2 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld