P1P P1S Flat Screen
Copyright Claim
P1P P1S Flat Screen
Boost
7
14
8
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
32 min
1 plate
Fast & Clean // 0.28mm layer // 2 walls // 10% infill
29 min
1 plate
Boost
7
14
8
0
57
51
Released
Description
P1P / P1S Parallel Screen Adapter
Set's the screen parallel to the printer
Compatible with Parallel Screen Shroud https://makerworld.com/en/models/23193#profileId-42554
Comment & Rating (8)
All
Print Profile
0.16mm layer, 2 walls, 15% grid infill
Good print, nice fit.
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% grid infill
I was not very satisfied with this print profile. The brim seemed really unnecessary and it is basically impossible to get the supports out from the holes which makes it impossible to attach.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
This worked out perfectly. Thank you so much!
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% grid infill
Good work, was a bit hard to fit the display in - but I had more support then needed by accident... Good job overall!
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% grid infill
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% grid infill
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% grid infill
1
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld