more than Halves the amount of filament used (down from 180 grams to 80 grams) for when you want magnets but not the extra weight and filament use of the "heavy" Gridfinity Base. This was what I wanted to design myself but found it already made. Thanks OP for the remixed series of plates. Side note: I did have adhesion issues which was odd on the original profile you made. I'm working on figuring it out but I think it either might be my black filament is not as dry as I thought OR its the elephants foot compensation making the first layer smaller by .15 and then printing on the inside corner and pulling that second layer off the first layer because the lack of overlap. I will update the review when I figure it out after this good adhesion test finished. NOTE: turns out it was neither of the above...I just edited out the wrong G-code in my custom "no prime line" x1 profile and it left the printer in relative mode which then printed in mid air....

Prints well. works as intended.

la grille ne paraît pas d'équerre ou perpendiculaire ce n'est pas un problème d'impression mais plutôt de conception je pense. je n'ai pas de problème d'impression sur d'autres objets qui ont un angle à 90 degrés

good print