This model is REMIX of @3d_printall ‘s Holgram Box to show case the Pepper’s Ghost effect.

ORIGINAL MODLE: https://makerworld.com/en/models/52773#profileId-126796

I redesigned the model to be printed flat at put together with interlocking joints. There is no glue needed.

I used 5x7 acrylic sheets purchased on amazon to finish the effect.

Acrylic Sheets 5x7 on Amazon

Assembly Steps

1.) Insert the bottom into the left and right panels.

2.) Insert the bottom half of both the front and back panels.

3.) Insert the 5x7 Acrylic sheet into the groves on the left and right panels

4.) Insert the top piece into the left and right panels

5.) Insert the top half of both the front and back panels.

6.) find a hologram video on YouTube, place your phone on top, and enjoy!