A Travel 9x9 Go board complete with pieces! Conveniently folds up to hold everything tidy while on the go!

I've created two of these that are similar in function, but with different styling. I am calling this one the “Traditional Styling” as it was modeled after an old wooden game board I had seen. It folds up in a clam-shell manner, with two cases inside that hold the pieces for each player.

The sides are identical, so print two sides, plus the mid section. Print a set of the player pieces and case for each color. There should be 40 player pieces total. On the X1/P1, I recommend printing without the Aux fan to help avoid warping. Make sure your bed is clean too! 

You'll need 4 M3x20 (there abouts, doesn't have to be exact) screws for the hinge, and 4 4x6mm magnets (Here's a link to an Amazon US listing). Be careful not to over-tighten the screws! You don't want a stiff hinge.