Awesome spinning top! (last picture)
**Tekk3D has fixed the following complains**
*I removed the support at the "Spitze" and scaled the "Stift" down to 98% (added as FIXED PRINT profile), now it works perfect*
Looks cool but assembling is impossible without heavy sanding. Would love to see a fixed version.
The print profile has a mistake - there is support on the "Spitze" (in the picture the one which has a closed surface).
The Stift doesn't fit.
Looking forward to get my hands on the fixed version!
Hey buddy, I have just uploaded a new print profile with 3 more connecting pins.
with the diameters 5.00, 5.025 and 5.05mm.
I think it depends on the respective filament calibration and the behavior of the material. I mainly print ABS, which certainly behaves somewhat differently than PLA.
I hope you are satisfied with the correction.
Thanks for your message and have fun while spinning :D
Finalement j'ai du ré-imprimer la tige centrale un peu plus petite, et parfait après cela.
Autant ne pas en imprimer au départ et l'ajuster ensuite ;)
Sinon, 1min57 après 3-4 lancé ;)