Ikea Skadis P1/X1 Mount - Improved hook design
Copyright Claim
Ikea Skadis P1/X1 Mount - Improved hook design
Boost
103
236
41
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
51 min
1 plate
Boost
103
236
41
1
249
141
Released
Description
Mount your Ikea skadis on the side of your P1S & X1C - Just remember to print out a Ikea skadis board to mount
Slightly improved design to fit any smaller gaps
Comment & Rating (41)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Perfekt vielen Dank
The designer has replied
1
Reply
No problem! Looks like you're using it with an X1? Does it fit well?
0
Reply
Replying to @Lebofly
Hi it fits perfectly on the X1C Thanks again
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
works well, I'm happy with it
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
thanks works as advertised for the 3d Skadis print.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Does its job well, no notes or complaints
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0,2 mm Schicht 2 Wände 15% Füllung
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Does this also fit the X1C?
The designer has replied
2
Reply
I’m not sure sorry
2
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
worked perfect
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
good
1
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld