Helicopter Kit Card (Bell 206B Jetranger) by pbbence1994

pbbence1994

Hobby & DIY>Vehicles

Print Profile(3)

All

P1P

P1S

X1 Carbon

X1E

A1 mini

0.2mm layer, 2 walls, 100% infill

Designer

2.4 h

1 plate

4.8(125)

0.2mm layer, 2 walls, 100% infill

Designer

2.4 h

1 plate

4.5(27)

Fix for A1 Mini

2 h

1 plate

4.2(22)

Boost

1366

2427

226

2.9 k

1.2 k

Released

Description

A fairly accurate kit card model of a Bell 206B Jetranger helicopter.With it's beautiful multicolor paintjob looks good as desk decoration, but it can also serve as a fidget toy, because the props can spin pretty satisfiingly well. Cut the part out with pliers or nail sissors. The assembly is easy and self explanatory. Have fun printing it!

Comment & Rating (226)

@nightshade_

Print Profile

0.2mm layer, 2 walls, 100% infill

had some adhesion problems on smaller parts but its a general problem for me at the moment, not just this model. Great design!

@user_3147983454

How did you solve the smaller parts not printing? Mine failed to print with all the little parts pulling away from the bed. Mine failed less than 10% of the way in

(Edited)

@nightshade_

Replying to @user_3147983454 :

uhm, well i just had some parts that werent fully loose, but started to lift from one side. I just pushed them down by hand while the printer was changing filament haha. Also i used a smooth plate and glue bc it really fucked me up

@NxtGnPrtHub

Alles bestens!

The designer has replied

@pbbence1994

Looks perfect!

@Loucee78

Print Profile

0.2mm layer, 2 walls, 100% infill

my first multicolor print. turned out awesome!

The designer has replied

@pbbence1994

Thanks! Looks perfect! Try my other models if you like it!

@sk_13s

good

@KoBuCRAFTS

nice print! 😜

@Koerhart

Looks nice

@bearlissimo

Print Profile

0.2mm layer, 2 walls, 100% infill

Fun print, thanks

The designer has replied

@pbbence1994

Glad you like it thanks for the rating!

@wellprintED

Print Profile

0.2mm layer, 2 walls, 100% infill

nice fun build!

The designer has replied

@pbbence1994

Glad you like it thanks for the rating!

@richprints3djax

Print Profile

0.2mm layer, 2 walls, 100% infill

love the model thanks great print

The designer has replied

@pbbence1994

nice print glad you like it!

@.s_.

heres a fun gif! these print really great. made a couple different color combos.

GIF

@Stevetalkowski

Print Profile

0.2mm layer, 2 walls, 100% infill

Bed Adhesion Issue:One corner of the frame warped up half-way through. Fortunately, it was done printing that portion, I was just hoping it wouldn’t ruin the surrounding area. The plate was cleaned prior to printing. The model is nice, however, the top propellor could have a tighter fit so it doesn’t droop to one side. Also, I was experiencing some color bleed on the upper vertical portion of the tail.

The designer has replied

@pbbence1994

Try to use some adhesion spray like 3dlac never had any adhesion problem since I use that. The propeller is looser on purpose to mimic the tilting of the prop a bit. Yes the model is thin to save material so bleeding can occur with translucent filament but you can color the other side too..

(Edited)