Wavy Pencil Holder - Vase mode
Boost
56
101
13
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
4.3 h
1 plate
VASE MODE 0.6mm nozzle, 0.3mm layer, 1 walls, 0% infill
1.8 h
1 plate
Boost
56
101
13
0
217
112
Released
Description
This model is design to be printed using a 0.6mm nozzle (0.4mm should be fine) in vase mode.
The print above is made from Prusament PLA Gentleman Grey
Recommended settings
- Material : PLA / PETG
- Vase mode
- Layer height : 0.2 - 0.4 mm
-----
Want to support my work ? Check the following link ;)
Donations : http://www.paypal.me/redarhd
Comment & Rating (13)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Very nice pencil holder, heavy and stable, printed with Sunlu Rainbow PLA filament. A few flaws (stringing) probably due to a high température inside the printer (the door was completely closed).
2
Reply
Print Profile
VASE MODE 0.6mm nozzle, 0.3mm layer, 1 walls, 0% infill
Excellent!
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
printed perfect! I did scale it down to use as a glue stick holder.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed great!
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed great, no issues
1
Reply
printen it with Matt red , first print warped a little, after proper enclosure print went great
1
Reply
Print Profile
VASE MODE 0.6mm nozzle, 0.3mm layer, 1 walls, 0% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld