Smaller egg designed to hold a mini articulated dragon. The small size will hold a McGybeer articulated dragon printed at 50% scaling (the “full size” is 83% scaled).
I think it's just a little too tight, fixing it has been on my to-do list but I keep getting distracted. If you run some fine sandpaper over the threads it should help.
I've been sanding for a while, still no joy (medium size egg).
Edit: The large version, while slightly better, will not screw together for me either :(
I think I may need to do some calibration of my filament for better dimentional accuracy, but I'm also pretty sure that these are not well implemented threads.
Which is a shame, because it's a nice model.
The small egg is very good, but the medium egg thread cannot be screwed in. Too much force even crushed the eggshell. I think there may be issues with the model of the medium egg
I very much appreciate the test threads so users can dial in their print settings (or confirm they're good) very quickly before proceeding to the full egg.