my mantel is loaded with these

I printed like 3 of each

amazing print fits well and looks awesome should’ve printed it with gradient pla but still looks wonderful

lot of fragility and had to reprint a few pieces and it falls apart a lot

needs a warning that it’s not connected

VERY FAT

strength is poor but it look very funny still with no legs

printed in abs and it failed on one part but still an a+ design

minor print issues but overall printed well I dont have the h2d so I can’t test it

don’t have the h2d but still printed and it curled off the plate (with generic pla silk)

don’t actually have the h2d but it printed very well

lot of parts and could you make an instruction pdf please?

printed well second try on a1 mini but I just had to add some glue. and it works most of the time, although it has popped off a few times

I perfectly aligns it every time. printed very well.

um so I tested it, does not work for the a1 mini

it gave my candy protection at summer camp but very easy to crack and I forgot to glue the plate that holders the latch in place.

it saggs a little bit. but otherwise HOLY MOLY YES! BEST PRINT EVER!! (I should glue it but the flippers break a lot) still, super cool!

first try failed, so I lathered the build plate in glue and that helped. for an almost completely flat kit card this is very not-flat! the instructions were very clear! landing gear… ahh… nope.

the top of its head doesn’t fit quite right

it printed but the corners failed