3D printed

Remix na A1 mini Bambu pre syna ktory ma rad custom pera do školy

Tuhy mam z alka 100ks za drobne.

treba zmerať priemer hrotu a pridať plus cca 0,5 ku priemeru špičky na vnútornej strane pera bol 1,9, čo som zaokrúhlil na 2,4mm

priemer tuby bol bol 2,2, čo som zaokrúhlil na 3,4mm nech je volne kedze tyhy boli +/- 1mm na dlzku

dlzka sa meria od priemeru spicku a konca zuzenia <=I od tialto cca <=I========= po koniec

pauzu som dal az za uzavretie hrotu, cca 5,48mm kvoli brnkaniu do tuhy.

text orig thingiverse

The ball point cartridges I am using are pretty standard. They were just a cheap packet of 20 generic pens I purchased at my local Office Works. However you will need to get out your digital callipers and measure them precisely and adjust the settings if they do not match. The tip_diameter on my pen inner was 2.14, which I rounded up 2.4. The inner_diameter of my pen inner was 2.9, which I rounded up to 3.4. The inner_diameter value can have looser tolerance than the tip_diameter to make insertion of the inner easier. The inner length is measured from just below the ball-point tip to the end of the inner.