Search models, users, collections, and posts
Mat Cutter
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
2.4 h
1 plate
Open in Bambu Studio
Boost
46
204
14
7
271
204
Released
Description
This mat cutter is a redesign of the Logan 1000 mat cutter, except it uses standard single edge razor blades instead of custom Logan blades. I Also made it a little larger and easier to grip. It cuts a 52 deg. beveled edge in standard mat board.
Print Settings
Printer:
UDIO
Rafts:
No
Supports:
No
Resolution:
0.2mm
Infill:
20%
Notes:
After printing, sand flat any ridges or lumps in the slot where the razor blade goes. Secure the clamp piece with two 6-32 screws.
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (14)