Magnetic Mario mushroom head iWatch charging dock, large internal space. Magnetic rear cover and bottom

The magnetic Mario mushroom head, the connection between the head and face, and the connection of the back cover use magnets.
The bottom can also be connected with a cylindrical block and glue, saving 4 magnets
Use 8 5mm*2mm magnets. If the bottom does not need magnets, 4 can be reduced.
It is recommended to use PLA for printing for better results. The white patches and the tail plate are also recommended to be printed with PLA, especially the tail plate, otherwise there will be two round black shadows. If you have correction fluid or white paint at home, it is recommended to apply it from the inside, which can greatly reduce the shadows.
It is recommended to increase the print density of the bottom face for better stability.
The face can be printed in white or flesh-toned, both look good.