DESICCANT BOXES FOR AMS FULL ULTIMATE

I have printed and tested many desiccant box models for my AMS All were very good, but each had something that could be improved, so I decided to create a new one and add all the ideas that emerged during this time to create the perfect model

AMS SILICA BOX ULTIMATE ANTI-SPILL

This model is compatible with the XIAOMI MIJIA hygrometer, if successful, I will upload models for other types of meters on the market

The hygrometer used is model: XIAOMI MIJIA

Link where you can get it: https://www.amazon.es/dp/B083Y1D8WB?ref=ppx_yo2ov_dt_b_fed_asin_title

The silica used for this model is: https://www.amazon.es/dp/B0CTKTNWR3?ref=ppx_yo2ov_dt_b_fed_asin_title

It can be printed in any material, I printed it in PLA-CF because I like the finish that filament gives

Material used - 244 gr

Filament used - PLA-CF

0.2mm layer height

2 walls

The following improvements have been made:

1. THE HUMIDITY READER'S POSITION IS NOT IN CONTACT WITH THE SILICA This is fundamental for the reading to be accurate and real

   

2. A DUCT IS CREATED IN THE TWO CENTRAL BODIES FOR CORRECT READING When placing the rear body, a duct with a rear outlet is created to read the humidity correctly

   

3. SINGLE-PIECE BODY PRINTING Many models are printed in two parts, which can be a problem as it may open when handled to remove or insert into the AMS, creating a mess with the silica

   

4. TWO BODIES, ONE FRONT AND ONE REAR Models tested with a single body waste space

   

5. FIRM JOINING OF THE TWO BODIES BY MEANS OF RAILS To improve the connection of the bodies, it is done via sliding rails so that they are firmly joined

   

6. A GRIP EXTENSION IS CREATED ON THE HANDLE When handling the boxes, the rear part has a protrusion on the handle for better grip and greater security

   

7. A SUPPLEMENT IS CREATED FOR BETTER AERATION AND EFFICIENCY To prevent the box bodies from sticking to the AMS wall, which would be ineffective, a supplement is created to provide a space where air can pass perfectly for greater efficiency

   

8. FOR INSTALLATION, IT IS NOT NECESSARY TO REMOVE THE FILAMENT SPOOLS Tested models require removing spools for installation, with the inconvenience this entails