Search models, users, collections, and posts
Drunk-O'-Lantern
IP Report
Print Profile(0)
Add the first print profile to earn points
Boost
10
17
0
0
6
0
Released
Description
This model was printed on a Sunlu S8 at 30mm/s, 5% infill with a .2mm layer height. I used the custom supports, (arch-buttress) in Cura to place under the two higher teeth. You can find the custom supports plugin in the Marketplace in Cura which will be the Custom Supports Cylinder plugin.
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (0)