Search models, users, collections, and posts
Dreambaby top toungue replacement
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 100% infill
Designer
15 min
1 plate
Open in Bambu Studio
Boost
0
1
0
0
3
2
Released
Bill of Materials
List other parts
- Spring x 1:
- Spring x 1:
Description
We had a second hand baby gate where this tongue piece broke, so it no longer shut automatically. I wish to learn how to use Bambu slicer so this was my first attempt at creating something. I'm sure some settings are not optimal, my PETG print didn't stick very well in one corner, but it still came out ok. I think there was some buildup on the nozzle that caused it to pile up.
I chose 100% infill for strength and PETG to increase longevity from repeated knocks. PLA might work fine YMMV.
The screw at the bottom allows the top panel to pop off, and the two pieces come out if you lever the tab on the inside. Two springs are inside.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)