Jogi's Bird Feeder / Bird-Feeder

Jogi's bird feeder is my own design, created after testing several models and seeking an improved solution.

Simple to print—three parts, no supports required.

Print with PETG or another weather-resistant material.

Easy to fill—simply remove the lid, refill, and replace.
For secure mounting, use a sturdy cord and ideally a small weight (M10 nut or similar) to prevent excessive swaying in the wind.

Secure the middle section to the base with a few drops of adhesive; the lid is simply placed on top—do not adhere it.
Thread the cord, fill, hang, and enjoy.

The multi-color print resulted from using leftover filament; it can, of course, be printed in a single color or customized in Bambu Studio with AMS.

September 22, 2024: Added a photo featuring the green version. I personally prefer the understated gray.

December 30, 2024: New version available:
https://makerworld.com/en/models/864451

This does NOT replace this version but supplements it as follows:
The lid is larger, offering better protection from rain.
The mounting ring is larger, providing improved stability in strong winds.
The holes in the middle section are larger, allowing birds to easily peck out seeds.
The lower opening is slightly larger to prevent clogging.
The lower tray is larger, ensuring seeds remain inside better (in windy conditions).
The parts are compatible; you can freely mix parts from both versions.

New tip: Thread one or two large washers onto the cord at the top to add weight to the lid.

Birds love it!