Search models, users, collections, and posts
Print Profile(1)
0.2mm layer, 3 walls, 15% infill PETG
Designer
3.7 h
1 plate
Open in Bambu Studio
Boost
80
277
27
21
185
122
Released
Bill of Materials
List other parts
- 8x2mm Magnets x 4:
- Mounting Screw x 1:
Description
Version 2.0 is now available here
https://makerworld.com/en/models/715718
V2 has some improvements. However if you don't want to embed the magnets, V1 still works great!
- Embedded magnets (pause a layer to push in the magnets)
- Thicker overall to perform better in heat or cold
- Additional mounting hole for single 2x4 mounting
Outdoor dog poop bag dispenser.
- Holds three standard poop bag rolls
- Magnetic lid and base requires 4x 8mm x 2mm thick magnets
- Side holes allow for quick inventory and stuffing your finger in there removes the cardboard roll core
- Two holes in the base back for mounting options. One screw is all that's really needed.
- No matter what your partner says, do it the right way and load the bag roll with the bags coming off the top of the roll (over method)
- * I was just being funny above, however after a week of using this, it actually works better with the roll coming off the bottom ;)
Print in PETG, ASA or ABS for outdoor use. No supports required.
License
This user content is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (27)