Search models, users, collections, and posts
Sand Castle Gate/Arch/tunnel Form
IP Report
Print Profile(3)
0.2mm layer, 2 walls, 9% infill
6.9 h
1 plate
0.16mm layer, 2 walls, 15% infill
8.5 h
3 plates
A1 MINI - 0.16mm layer, 2 walls, 15% infill
9.7 h
3 plates
Open in Bambu Studio
Boost
294
995
22
9
332
208
Released
Description
This is a form for creating castle gates, arches and tunnels with sand.
this simply gives you something to pack sand against and creates a clean opening in the sand.
One version has a flange that simulates a stone arch patern. If you want the stone pattern on both sides there is a second form that you can insert in the first one to get the pattrn on both sides.
The other version deos not have the flange.
Pulling the form out is a delicate operation but, take your time, wiggle the form gently as you pull back and you should get decent results. I also suggest pushing down on the form from the inside as you pull it out.
Printing
Print with handle side down.
No supports, nothing special.
Enjoy!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (22)