Search models, users, collections, and posts
Panels For AD5M Enclosure
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 30% infill
6.6 h
4 plates
Open in Bambu Studio
Boost
68
91
8
1
184
5
Released
Description
These are panels for the Flashforge AD5M enclosure. Its a cheap alternative to buying the clear panels. Each panel takes around 4 hours of print time using a 0.6mm nozzle and 30% infill using the Flashforge PETG profile. I used the same magnets needed for the rest of the enclosure to join the sides. The top and door panel I used superglue.
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (8)