Search models, users, collections, and posts
QIDI Q1 Pro hotend air duct(cool down much better)
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
13 min
1 plate
Open in Bambu Studio
Boost
77
121
21
6
442
11
Released
Description
Easy to print, low-cost, but solves a big problem!
QIDI Q1 Pro is a great printer, equipped with a heated chamber, which is very friendly for printing high-shrinkage materials like ABS. I really like it.
However, when printing with low-temperature materials, it often suffers from nozzle clogs and inconsistent extrusion, which can be quite frustrating. So I designed this little thing to help the hot end dissipate heat better, alleviating those annoying issues. It’s also very low-cost, and if you have the QIDI Q1 Pro, this mod is well worth it.
- About the assembly:
- No additional screws are needed; just use the original factory screws.
- You need to remove the two M2.5 screws that secure the fan, then align the screw holes of the air duct, and finally tighten the two M3 screws that hold the hot end.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (21)