Print Profile(1)
Description
This was updated from the original models to support the Barrina shop lights. This is a set of brackets for a modular grow tower that fits on the mounts on the outer sides of the tower. These fit the Barrina T5 shop Light 3' and 4' versions.
Endcaps should be printed in petg and need to be slowly tapped onto the lights from the edge in. These are meant to be tight. Tapping too hard can cause the clips to snap so print extras. If you use PLA they will be two brittle to get into place. Once these are on the aluminum, and past the plastic ends of the light, they will be able to be moved with some force to their final locations.
The light bar snaps into place between the tabs on the end cap. This should be fairly simple to install and requires a small amount of force to snap into place.
To install these onto the mounting holes, use a 25mm m3 screw (I used stainless steel) and the included spacers.
Nuts/Bolts needed:
---------------------------------
6 - M3 Bolts
6 - M3 Nuts
This remix is based on
License
Comment & Rating (33)