Pry Bar Rail Mount For Milwaukee Packout Boxes
Print Profile(1)
Description
This is a rail mounted prybar holder for the Milwaukee Packout boxes that have the metal rails on the corners. This design uses two M5 screws (up to 20mm in length, I used 16's) to clamp this holder to the rail unlike other mounts that require the rail to be removed or some type of set screw that leaves marks on the rails. I have also added a hole in between the mounting screws that allows for storage of a Milwaukee Inkzall marker. The marker is very close to the box in the picture, but I have updated the file that is published to be pushed out a little bit more.
I based this design off of the Pittsburgh prybar set from Harbor Freight since I didn't have any others available. I have listed the sizes of the holes below so you can measure your prybars to make sure they will fit before wasting time or filament printing this.
Largest Prybar hole - 20mm
Second largest prybar hole - 20mm
Third largest prybar hole - 17mm
Smallest prybar hole - 11mm
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (27)