Search models, users, collections, and posts
9 yuan 65W charger
IP Report
Print Profile(1)
0.2mm layer, 5 walls, 100% infill
Designer
1.1 h
1 plate
Open in Bambu Studio
Boost
1
0
0
0
0
0
Released
Description
Content has been automatically translated.
9 yuan 65W charger
Requires filling with thermal paste, recommended to print with ABS/ASA or higher temperature resistant filament
The board is from the shop shown in the picture below, around 9 yuan each
High yield rate (2/2)
Use a thick two-pin plug
Protocol as shown in the figure
License
This user content is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)