Towel Rails, Brush Holder, Toilet Paper Holder

For my new bathroom, I was looking for suitable accessories that matched my wall color, but found nothing,

so I designed something myself.

I have designed many things before, but this is my first upload.

The set includes:

• Towel rail 360mm
• Towel rail 460mm
• Towel hook 23mm
• Towel hook 38mm
• Towel rail 560mm
• Side towel rail 300mm
• Shower holder
• Shelf
• Brush holder
• Toilet paper holder

All items are equipped with concealed holders and attached to the wall with one or two countersunk screws each.

All outer walls are covered with a fine fuzzy skin to achieve a nice texture and hide layer lines.

The long towel rails have an internal bore for an 8mm guide rod, which I glued in to achieve stability

and prevent the holders from breaking off with a heavy towel.

The names on the long towel rail are not included in the print file, only on mine.

It's up to you whether you print names or something else with it.

The toilet brush holder also has a removable insert for the brush itself.

The insert sits tight enough so it isn't pulled out with the brush, but still loose enough,

so that it can be removed for cleaning or disposal.

I sealed the inside of the insert with clear lacquer to prevent water from entering the actual holder.

The tolerances are chosen very tightly so that everything fits well and nothing wobbles.

Depending on how well your printer is calibrated and the filament used, it might be a bit too tight or too loose.

Perhaps make a test print for the holders and for the towel rails to check if the 8mm

rods fit.

You might then need to scale the holders 1% smaller or larger.

I printed everything with SUNLU PETG Olive Green, all without supports.