Attachment Brush Cutter Einhell Agilo V2

Thank you very much for this great project. I deliberately did not print the attachment with normal PLA again, as PLA is far too brittle for the forces involved and the high speeds in my opinion. For safety reasons, I think it is therefore better to do without normal PLA. Instead, I used PLA-CF and achieved very good results with it. The double thread works cleanly and stably with it. I have now also printed the brush cutter attachment with eight threads for my Scheppach – it also fits very well. A small tip for other users: The 2 mm holes became slightly oval or collapsed a bit due to printing, so the cord no longer fit through cleanly. I therefore reworked the holes with a 2.5 mm drill bit, after which everything worked without problems. The practical test with the eight-thread attachment is yet to follow, but the initial impression so far is really very positive.

the print came out great