Dogs vs. Cats Chess Set 2in1

Dogs vs. Cats Chess Set

I printed them, the tallest figure is 80mm, the rest are correspondingly smaller. 
Of course, you can scale them up to make them even bigger, they'll look even nicer :)

To extract more detail, you can print with a 0.08mm layer and a 0.4mm nozzle.
A 0.2mm nozzle would definitely be useful for these models.

eSUN High Speed PLA+ filament (Bone White)

*0.12mm High Quality @BBL A1; 0.4 nozzle; 3 walls, 95% infill

I publish my models only on the MakerWorld.com platform.

Happy printing!
 

To print my models before posting them on MakerWorld, 
I use the BambuLab A1 and P2S printer + the [BIQU Panda Buildplate CryoGrip] and [BIQU Panda Buildplate CryoGrip Pro Frostbite] plate, 
which has much better adhesion than standard PEI. 
Remember to make sure before you start printing that your plate is ready for printing, it should be clean and degreased.


The models are so detailed that you need to be careful when removing supports for small elements (e.g., hands, fingers). Of course, this problem is significantly minimized when printing at a larger scale. Remember to exercise extreme caution.

Make sure the print profile is adjusted to the filament you're currently printing with. 
Remember to adjust the print parameters to the filament you're printing with. 
Even regular PLA requires different print parameters, especially the Silk or Matte PLA versions. 
Also, make sure your filament is properly calibrated to ensure smooth prints.