Mountain Bike Blukar LED Headlamp Adapter Clip
Print Profile(1)
Description
Boost Me (for free)
If you like my designs, please consider boosting me to show your support!
***PLEASE CLEAN YOUR BED PROPERLY BEFORE PRINTING. DAWN DISH SOAP(Or Equivalent) AND HOT WATER THEN DRY WITH PAPER TOWEL OR AIR DRY!! NOTHING ELSE NEEDED!! THIS WILL ENSURE YOUR PRINT IS SUCCESSFUL***
## These models printed as shown but if you dont clean your bed properly and have adhesion issues, then you can add a brim or mouse ears. I test all my prints and it is proven to print as I set it up. ##
Mountain Bike Blukar LED Headlamp Conversion Adapter Clip
*** USE MINIMAL PETG OR A MORE HEAT RESISTANT FILAMENT FOR BEST RESULTS TO MINIMIZE HEAT WARPING AND LOOSENING OF THE CLIP ***
I designed this clip using Tinkercad to convert the Blukar LED headlamp into a mountain bike headlight. These are pretty affordable, rechargable and bright. This clip is designed specifically for this headlamp and may not fit other brands.
By removing the head band strap, you can then use this clip to snap into the back side of the mount and then clip onto your (32mm section near the neck) mountain bike handle bars I have made the clips pretty tight and have not had them move on the trails even on the bumps it seems to hold solidly.
Supports should be pretty easy to remove, I was able to pinch and bend them by hand to where they eventually slid out or came off.
Membership
Join my Commercial Membership and enjoy selling rights for all of my models for as low as $3 per month.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)