Touchland Case - Tuxedo Sam

This is a remix based on https://makerworld.com/en/models/2253497-touchland-case-pip-latch-keychain-loop#profileId-2456907. I have added the cartoon character Tuxedo Sam to the back. Kudos to the original author. 

There are FIVE (5) colors, which exceeds the capacity of my 4-color AMS. However, below is what I did to print this successfully:

1. When sending the job, assign YELLOW to the BLACK slot.
2. Sit in front of the printer and watch.
3. Right after BLACK is switched out, load YELLOW to the BLACK slot. 
4. No further action is needed. It should print correctly through the end.

It's highly recommended that you use a smooth build plate to achieve the best result.

Keep your sanitizer within reach and protected!

This is a custom-designed case for Touchland Power Mist (1 fl oz / 30ml) hand sanitizers. Whether you are clipping it to a purse, backpack, or gym bag, this holder ensures you never have to dig around for clean hands again.

✨ Key Features:

• Print-in-Place Mechanism: Designed with a built-in hinge and latch system. No screws, glue, or assembly required!
• Secure Latch: The snap-fit latch keeps the bottle securely inside while allowing you to easily pop it open to swap out refills in seconds.
• Keychain Ready: Features a sturdy integrated loop so you can attach it to a carabiner, keyring, or lanyard.
• Accessible Design: Print profiles that don't require AMS and those do are available. It looks great in PLA, PETG, or Silk filaments!

🖨️ Printing Instructions:

• Orientation: Print flat on the build plate (as shown in the slicer).
• Supports: Supports not required, however supports on the latch bar are recommended.
• Infill: 15% - 20% recommended for durability, I used 25%.
• Material: Works great with PLA, PLA+, or PETG.