Q990F Custom Amp Box

Q990F Custom Amp Box to allow you to run a powered active sub in your system.

No splicing or cutting of original wires if used with this harness https://ghentaudio.com/products/vhr-2n-harness?srsltid=AfmBOopKyWF_VXUv1ty4BcuE8YqawpqZXsaF3AT1Vxn7PdqAkFV6IqAO&VariantsId=12538

Quick guide: 

Start by carefully taking out the screws on the original Q990F sub and then take out all 4 cables connecting to both of the boards.

Remove the power connecter and pairing board from within the subwoofer box. The 4 screws can be quite fiddly to remove as the gap is tight but I found it easy with this tool: https://www.amazon.co.uk/OSDUE-Phillips-Screwdriver-Reversible-Ratcheting/dp/B0B4N2LVLH/ref=sr_1_6?crid=12B3Q89KX7YRO&dib=eyJ2IjoiMSJ9.Mc0X8KKQxBfs35YGmozhsR9IhI6Fc-eIrJs-TDKgY49oUxYAFT5It8d-6ZkPD0HuT00F82xkwh5NE2062wf2i48Fkip4g0YzWlaqs53k7vcYHWE506WngTgKmdyNNoImn88Ug8TgosIRHQIf6u3p4Un6424vZFjjU4BTzHOK_1FIXfYjfPv-VFJRerMFbNrtd4RTdRw-jLT1WRx-CaRsryG7jylGQqhBlfoXWqOUcfOwFs8zkY2fZtXbfzeK5s_4gsJAv77FKqitCIud5wpg21AlbXf6QR0FeFoZbHcIUPI.V1W3sZSW62sHxvAqoBZb6iU0nv9LXNsoQ5Xx6MFVa1U&dib_tag=se&keywords=small%2Bangle%2Bscrewdriver&qid=1773669575&sprefix=small%2Bangle%2Bscrewdriv%2Caps%2C243&sr=8-6&th=1

Place the power connector on the outside of the printed box and feed the cable inside along with the 4 speaker cables.

Stick down the pairing board on the bottom side of the box with double sided tape.

Connect all of the wires back on to the board and then screw the board down onto the box. I used 4 screws but 6 can be used.

Glue together the 2 top pieces, this acts as a lid to keep the box from opening in the middle.

Connect speaker cables to sub before on.

Enjoy new sub!