SMOOSHER | Ram Extension for ATinyDesk Can Crusher

What is this?
This is a clip-on spacer/pocket that fixes the #1 frustration with the ATinyDesk aluminum can crusher: the ram stroke is too short to fully crush a standard 12oz can on its own. Rather than modifying the tool or applying awkward pressure, this adapter spaces the can forward into a secure pocket so the base end of the can is captured and held fixed — eliminating the spinning, pivoting, and wandering that kills a clean crush.

How it works
The spacer clips directly over the existing ram — no tools, no hardware, no permanent modifications. Drop your can into the pocket with the drink opening and pull tab facing out (the face of the tool shows the correct orientation so there's no guessing). The captured base keeps the can locked in place through the full stroke.

Why it matters
Without it, the short stroke means you're doing half the work by hand and fighting the can the whole time. With the spacer seated, the crusher actually finishes the job — one clean stroke, can stays put, done.

Print settings

• Material: PETG or PLA+ recommended (needs to handle repeated impact loading)
• Infill: 40%+
• Walls: 3+
• Supports: Not required

Compatibility
Designed for the ATinyDesk Wall-Mounted Can Crusher. If you own that crusher and have been fighting it, this is the fix.

Purpose-built designs. No gimmicks.

All models published here are created to solve real, physical problems encountered in daily use — with attention to fit, function, printability, and long-term usability.

Designs are tested in real setups whenever possible and released iteratively. Feedback and constructive suggestions are welcome.

Versioning & Updates
Models may be updated as improvements are validated. Check the version notes and comments for the latest changes.

Feedback & Contributions
Thoughtful feedback, photos of real installations, and improvement suggestions are welcome.

Licensing
Personal use is encouraged. Please review the license before redistribution or commercial use.