Tookie 140W GaN Charger Stand | Anti-Slip

😅 Why I designed this? (The "Official" Reason) Let me be clear: I definitely did NOT lose the original stand that came with the charger. Absolutely not. It's just that... the original stand lacked a front stopper, so the charger would slide out whenever I pulled a cable. (Okay, fine. Maybe I lost the original one. But this one is better anyway!)
 

✨ Key Features

• Front "Bump" Stop: Unlike the standard stand, I added a lip on the front. This prevents the charger from sliding forward when you pull on the USB cables.
• Perfect Fit: Designed to hold the Tookie 140W GaN charger snugly, yet it allows for easy removal without using excessive force.
• Rear Cable Access: Features a precise cutout on the back for the power cord (C7/Figure-8 cable) connection.
• Desk Mounting: If you secure the bottom of this stand to your desk with double-sided tape, you will never experience the charger being dragged along when unplugging your devices. It stays rock solid!

🖨️ Print Settings & Technique

• Material: PLA
• Supports: Required.
• 🚀 Advanced Setting Used: I utilized the new "Support Interface Ironing" feature in Bambu Studio.
  • This technique irons the top interface layer of the supports, making the surface above it (the charger contact area) incredibly smooth.
  • Result: The supports detach very cleanly, and the overhang surface quality is fantastic.

📝 Notes

• Enjoy your "upgrade" (or replacement for the lost stand)!

Happy Printing!