RC auger for Yi gong rc excvator

An auger for an RC Yi Gong excavator

This little drill can be used to loosen dirt or to drill holes for mini power lines and fence posts.

• simple yet astounding.
• amazing power!
• almost no filament(12g)
• 2 hour print time.
• quick assembly 
• 2 screws required
• a special wire needed
• soldering skills needed
• 1, 12v 100 rpm N20 motor

Notice!

here is a link to the wire that will hook up to the excavator https://www.amazon.com/s?k=mini+led+tube&crid=21Y0WI7ZKL01M&sprefix=mini+led+tube%2Caps%2C199&ref=nb_sb_noss_1

I used 2 ,M2.3 x 12 x 6, self tapping screws.

n20 motor https://www.amazon.com/HiLetgo-GA12-N20-Reduction-Deceleration-Multiple/dp/B0CHRXGTHZ/?

select 100 rpm and 12v

cut of the usb side of the cord.

then strip and solder to the N20 motor

plug the cord into the bottom of the boom where a little port is visible

press the 2 unused buttons on the remote to run the motor in either direction